Nice! I assume the 10u version uses the same schematic as the 12u, just dropping the outer pinkie columns? In that case you can use the 12u firmware unmodified.
You could test with the default keymap, check your soldering for shorts, and try USB logging.
I meant the default keymap from the keyboard’s own config repo, but building from unmodified Miryoku ZMK main might be worth trying too if you can’t find anything else. Good luck!
I just built cheapino 3x5_3 split and of course need to get miryoku on it - there’s a qmk branch here github.com/tompi/qmk_firmware/tree/cheapino but could not find the board over at miryoku....
cheapino is using the split_3x5_3 layout that Miryoku QMK already supports, but cheapino doesn’t have community layout support enabled, so it won’t be used. If /u/Tompi@discuss.tchncs.de fixes that you’ll be able to build by merging branches and building for cheepino. You can merge the cheepino branch automatically at build time by using tompi/qmk_firmware/cheapino with the Miryoku QMK build workflow branches option.
So I’m trying to follow the instructions from the old reddit community to build the miryoku firmware for [seeeduino_xiao_ble, chiper36, Colemak, default, Mac, flip, default, default, default, default]....
The branch selector in the workflow is for choosing which Miryoku ZMK branch to build from. Unless you’ve made your own branch in your fork or you’ve manually sync’d an experimental branch from upstream, you’ll only have the main branch in your fork.
The branches field in the workflow is used for selecting and merging ZMK forks and branches. That’s what you need to do here, so put zmkfirmware/zmk/main in the workflow branches field.
That issue was specifically for revxlp (being one of the few boards that required a ZMK fork), not for xiao ble in general. Can you link your failed build run? I don’t know chiper36, so unless it’s compatible with an already supported shield (and you build for that shield) it won’t be supported. See github.com/manna-harbour/miryoku/discussions/81. If you have a ZMK keyboard definition for it I can add it to Miryoku ZMK.
I built this lovely bastardkb skeletyl and initially used a bit with miryoku kmk. I noticed for whatever reason that sometimes the right side hung up and now after flashing the latest kmk it does not seem to work at all....
Miryoku for revxlp 10u (lemmy.world)
Great progress on #revxlp 10u now that batteries arrives. This time, even with pogo pins…...
Miryoku for Cheapino
I just built cheapino 3x5_3 split and of course need to get miryoku on it - there’s a qmk branch here github.com/tompi/qmk_firmware/tree/cheapino but could not find the board over at miryoku....
OC My DD: 36-key Cantor variant
miryoku seeeduino build
So I’m trying to follow the instructions from the old reddit community to build the miryoku firmware for [seeeduino_xiao_ble, chiper36, Colemak, default, Mac, flip, default, default, default, default]....
Best Miryoku firmware for a hand-wired, split, wired skeletyl (lemmy.world)
I built this lovely bastardkb skeletyl and initially used a bit with miryoku kmk. I noticed for whatever reason that sometimes the right side hung up and now after flashing the latest kmk it does not seem to work at all....