Comments

skotimusj, 1 month ago to 3dprinting in Question about printing times

As you said. I tried this and it fixed everything. Thank you

skotimusj, 1 month ago to 3dprinting in Question about printing times

They are flat

skotimusj, 1 month ago to 3dprinting in Question about printing times

Thanks. Will try this.

skotimusj, 1 month ago to 3dprinting in Question about printing times

When I switch to 0.2mm the time goes to 83 hours, so I assume there is still some error. What slicer do you use?

skotimusj, 1 month ago to 3dprinting in Question about printing times

Here is what I remember.

Creality ender 5 s1 Creality slicer High detail profile (Infill % 15, speed 100, nozzle temp 205, bed temp 60, z axis 0.1) PLA These were the default with no changes.

I am not sure what other parameters can be changed.

I will post a screenshot tonight. I did notice that 99% of the time is on the outer wall, this is where I noticed the pauses when I simulate the print.

skotimusj, 1 month ago to 3dprinting in Question about printing times

Layer height is 0.1mm. it’s odd, because it happens on specific curved areas. There are no pauses on other areas that were recently printed.

skotimusj, 2 months ago to retrogaming in Anybody have favorite Master System games?

Shinobi and choplifter were my favorites.

skotimusj, 2 months ago to guitars in Just started learning the F barre chord. How was your F barre chord journey?

Everyone feels this way. For me, positioning my thumb and holding the guitar neck closer to 45 degrees made this cord (and almost everything else) much easier. When you are struggling, it can also mean that your hand muscles are getting tired. Take a break and come back to build up strength.