youtu.be

9.5" Inch 4140 Gearbox Shaft Part 1 (30:51) (youtu.be)

First of a short series of videos about machining a 9 1/2" gearbox shaft. This shaft is very similar to my past Heavy Metal Machining series, so I try and give you guys some different angles, and information I may not have shown before. In this video we get the ends centered, set up in the Pacemaker and begin roughing the shaft...

1971 HIWATT CUSTOM 50 DR504 | AMPS THIS BEAUTIFUL Don't Need 'Repair' [32:26] (youtu.be)

In this video, we’ll look at a 1971 Hiwatt Custom 50 in need of some service attention. We’ll also set the bias and talk about the pros and cons of setting the bias according to onset of crossover distortion on the oscilloscope vs the 70% plate dissipation rule. In the end, we’ll demonstrate the tone in a band setting,...

  • All
  • Subscribed
  • Moderated
  • Favorites
  • normalnudes
  • tsrsr
  • DreamBathrooms
  • thenastyranch
  • magazineikmin
  • hgfsjryuu7
  • Youngstown
  • InstantRegret
  • slotface
  • everett
  • rosin
  • ngwrru68w68
  • kavyap
  • PowerRangers
  • Leos
  • ethstaker
  • GTA5RPClips
  • Durango
  • cisconetworking
  • osvaldo12
  • vwfavf
  • khanakhh
  • mdbf
  • cubers
  • modclub
  • tacticalgear
  • tester
  • anitta
  • All magazines