I am still developing technique but it’s relatively straightforward.
Spray pain on water, then dip the piece. It takes a little practice to start getting some good results. Rotating slowly as you lower it seems to help. Dipping more than once can be a smart idea. Warm water is better than cold water.
I figured I’d try out lemmy on a problem I am having with my recent prints. If you’d like to help, see the following videos of the two models I have been having Issues with:...
My primary argument is that they post hateful content and covid conspiracies and it is irresponsible to platform this by including it in our federation. Secondly we already got rid of lemmygrad. Thirdly, there's little to be lost in the defederation given the type of stuff being posted over there. Do as thou wilt...
Hey there, first post – hope it's okay to put out a request for some advice. I just started 3D printing a few weeks ago (got an Ender 3 S1) and contrary to seemingly everyone else online, I've had no issues whatsoever with bed adhesion, rather the opposite....
Using a gluestick on the bed isn’t just to help create good adhesion. It also acts as a barrier between the hotbed and the part. This greatly helps with part removal.
David by Michelangelo, Hydrodipped (sh.itjust.works)
Help - Layer delamination (imgur.com)
Hi there,...
Dalek - Hydrodipped (sh.itjust.works)
(2021) Artictle about 3D printed tissues/organs (www.ncbi.nlm.nih.gov)
Dancing Lady - Bertel Thorvaldsen (sh.itjust.works)
(Help Request) Support Setting Issues (www.polymerpeculiarities.com)
I have been printing a number of sculptures this week and while mostly good, I am seeing repeated issues associated with settings....
The staircases of SF (www.sftourismtips.com)
One Square Mine Sweeper (onesquareminesweeper.com)
Average & Median Runs scored and allowed by the Padres per week. (imgur.com)
[Vote] Should we defederate exploding-heads?
Say “aye” or yes" if you are in favor of defederation....
[Help Request] I have been seeing some degraded print quality over the last few prints.
I figured I’d try out lemmy on a problem I am having with my recent prints. If you’d like to help, see the following videos of the two models I have been having Issues with:...
[Vote] guess I gotta make a post for this over here. Do we defederate with exploding-heads.com
My primary argument is that they post hateful content and covid conspiracies and it is irresponsible to platform this by including it in our federation. Secondly we already got rid of lemmygrad. Thirdly, there's little to be lost in the defederation given the type of stuff being posted over there. Do as thou wilt...
Announcement: Embracing a New Chapter: Towards a Community-Guided Direction and Accepting Donations
Hey all...
Are there any 3d models available for battletech mechs?
My brother would like a 3d printed chess set
Removing prints from bed cleanly
Hey there, first post – hope it's okay to put out a request for some advice. I just started 3D printing a few weeks ago (got an Ender 3 S1) and contrary to seemingly everyone else online, I've had no issues whatsoever with bed adhesion, rather the opposite....