mooklepticon

@mooklepticon@lemm.ee

This profile is from a federated server and may be incomplete. Browse more on the original instance.

mooklepticon,

Theres a cereal bowl to the left. No bananas in it tho.

Desk knick knacks.

mooklepticon,

There’s a cereal bowl on the left if that helps.

mooklepticon,

I wouldn’t do that in the slicer, it’s too hard to align them. I don’t know about any alignment tools in slicers. I could do that in Fusion360, however.

mooklepticon,

Got them for free, other wise I wouldn’t. They’re also only 3 gallons, so a lot easier to handle. Haven’t tried them yet, but a porter is going in this weekend.

mooklepticon,

So far so good. It clamps around the body of the printer. It’s not just sitting on it.

mooklepticon,

Yes. There are several I’ve seen advertised but I’ve never used. Pcbway, despite the name, has 3d printing services. I have no experience with them.

mooklepticon,

I don’t like curves in 3d prints, generally. They’re all chamfered. The original has some curves.

mooklepticon,

I did try a brim. It was a huge hassle to remove. I don’t mind brims on larger, simple parts, but on these smaller, intricate ones, it sucks.

  • All
  • Subscribed
  • Moderated
  • Favorites
  • •
  • provamag3
  • cisconetworking
  • DreamBathrooms
  • tacticalgear
  • Durango
  • everett
  • magazineikmin
  • ethstaker
  • thenastyranch
  • Youngstown
  • slotface
  • mdbf
  • kavyap
  • GTA5RPClips
  • JUstTest
  • ngwrru68w68
  • InstantRegret
  • normalnudes
  • osvaldo12
  • cubers
  • rosin
  • khanakhh
  • tester
  • anitta
  • megavids
  • modclub
  • Leos
  • lostlight
  • All magazines
    •