Overnight print is off to a solid start. I haven't done one this big in a while and I'm excited to see how goes the gradient filament. Also, the estimates for how long this print will take are crazy. Maybe it will still be running at 18:00 tomorrow?? That's not what Cura said. But we shall see!
@beandev Ich würde es erstmal in PLA drucken. Ja PLA kann sich über die Zeit verformen, dafür ist das Teil ruck ruck wieder neu gedruckt und getauscht.
Dafür würde ich mir den Stress mit ABS nicht antun. Natürlich unter der Vorraussetzung dass man einfach an das Teil ran kommt um es zu tauschen 😉
All done 🤩 My first version of a 3D printed bedside table is ready for release 😁
The table is 36cm x 36cm x 55cm and completely 3D printed in 👉👉vase mode👈👈. Technically no glue is needed cause the single parts interlock but for extra stiffness I'll glue the tabletop parts together 😉
The single parts are designed to fit on an ender 3 size bed and will be released soon on printables 😃
@stooovie ok even after the half of the print, it sticks super flat to the build plate.
Another thing that came to my mind was, have you checked the consistency of your heat bed? Maybe some areas have different temperatures than the others. This could explain why larger PLA prints fail/warp. Cause PLA is super subsceptible to heat changes. So of that's the root cause of the warping, try to turn the heat bed off at all. PLA don't actually need a heated bed to be printed.