zcd

@zcd@kbin.social
zcd,

Elon just trying to dial up the racism probably

zcd,

Why go through all that effort when you can just replace one CEO?

reginasbread, to weightroom
reginasbread avatar

Hello, is this magazine for more or less newbies too? I've never used reddit, so I don't know what rules your subreddit had.
I used to go to power pump classes, then exercised with a trainer, now I made my own basic workout routine (strength training plus cardio). I'm a chicken lifter for now teheheh, but I'd like to have a community. it's better together and all that.

zcd, (edited )

@reginasbread /r/fitness was generally geared towards beginners and /r/weightroom more intermediates and above, with stricter posting guidelines and the expectation that beginners do rudimentary research beforehand. That being said, /r/weightroom has always been supportive of novice lifters and was a valuable resource for anyone interested in getting bigger and stronger (after directing them to read the fitness wiki)

zcd,

Also keep in mind before the blackout /r/programming posted that they were seeing tons of posts and comments by bots, and suggested there was an astroturfing campaign in full force. Wouldn't put it pass /u/spez

Can I clean the gunk out of the bearing without disassembling?

My EDC is a Buck Sprint Pro and it's getting difficult to open. The knife has a bearing at the pivot point, and dirt is getting in there. I want to clean it out and regrease it, but I really don't want to take it apart if possible. I will if I have to, but I've never disassembled a pocket knife before.

zcd, (edited )

You can wash it with soap and water, opening and closing it repeatedly, then rinse well. If you have a compressor or air canister, blow out it out thoroughly, then put it in a sandwich bag and spray it with wd40 and let it sit in there for a while. Take it out and wipe it off a few times / blow it out, add a few drops of your preferred lube to the pivot and work it in a few times by opening and closing the knife and you should be good to go

zcd,

Absolutely not, /u/spez is a complete wank and the upcoming IPO just ensures this type of behaviour is going to continue.

zcd,

Doubling down on the hubris, its a bold strategy cotton lets see if it pays off for em

zcd,

That's pretty impressive, I have two accounts but think I've settled on kbin

zcd, to weightroom

I'm not sure if /r/weightroom has gone dark or not, but I thought some might be interested in a replacement here on kbin for their weightlifting training logs, program discussions, questions, etc

zcd,

Almost 13 years since the last migration, feels strange to be washing up on a strange new shore again

  • All
  • Subscribed
  • Moderated
  • Favorites
  • JUstTest
  • tacticalgear
  • DreamBathrooms
  • InstantRegret
  • magazineikmin
  • Youngstown
  • everett
  • cisconetworking
  • slotface
  • GTA5RPClips
  • rosin
  • thenastyranch
  • kavyap
  • mdbf
  • Leos
  • modclub
  • osvaldo12
  • Durango
  • khanakhh
  • anitta
  • provamag3
  • ngwrru68w68
  • cubers
  • tester
  • ethstaker
  • megavids
  • normalnudes
  • lostlight
  • All magazines