😿 the 0.6 nozzle was clogged too. I definitely cleared that clog though.
ALL of these clogs have ultimately been due to filament doing things it wasn't supposed to: breaking + ??? (with the wood impregnated), getting tied in a "knot" so it couldn't be pulled off the spool, and breaking because brittle from too wet... i think.
I've replacement nozzles & the https://noclogger.com/ tool @gooba42 recommended after watching a vid. Maybe it can save my 0.4mm.
it's time to refill my daily drug dispenser thing. Picked up the Adderall bottle and there's one pill left.
Of course, I couldn't order a refill last week like every other effing drug. Nah, I may be a drug dealer! I have to wait until < 3 days before i run out, and THEN ask for a refill.
It's REALLY not hard to write an algorithm that notices someone attempting to shift a schedule to get more drugs. But no, give the people with memory issues the responsibility of compensating for your fear.
I need someone to create a tiny robotic car with the footprint about the size of a Deck of Cards and hopefully not much taller that will act like a Roomba on my floor, but with a powerful magnet instead of suction.
I need something to find all the screws and nuts I have dropped
@Natanox@logicalmoody I honestly don’t think the problems have anything to do with a printer, although I do think that a bed slinger would be worse because I theorize it would induce more wiggle.
From my testing last time ( see the toot i linked in my reply to myself), it really does seem to just be an artifact of those two skinny sections