3dprinting

I was printing PLA, it looks ok up to a certain height (although it was warping slightly), but then it becomes ugly. I will do a test print of the same height, butaybe you already have an idea.

What’s the maximum layer height I can achieve on a consumer 3D Printer?...

You can see where around corners and even some straight runs it is peeling up. I’m running first layer at an agonizing 15 mm/s. Using hatchbox pla filament, just dried in dehydrator. 200° nozzle and 70° bed. The glass is freshly cleaned with soap and water, I just did several atomic pulls, I’ve trammed at different heights...

I’ve wanted one of these for a while, decided to bite the bullet a couple days ago! Seeing as I was somewhat familiar with CAD software (from engineering classes several years ago) it seemed fairly straightforward....

I forgot to put back the metal plate on my Anycubic Kobra 2 and pressed print. Managed to stop it relatively quickly but still damaged the heating surface a bit and it chipped away some of the material as you can see. How fucked am I?

I created this clip for my local makerspace, because I didn’t find one that suited all our needs. Therefore it’s already tried and tested by tens of people....

Here’s a small update to my bento box building log....

I got a P1S for my family as an early Christmas present. I’m interested in creating parts that may eventually be used in cars, so I’m trying to get things ready for full-time ABS and ASA production....

The legs broke as always but now I just glue the pieces in and it’s fine!

Some parts reattached in the corners as you can see, i’m assuming because they managed to peel off the fep there down the line....

Probably the most satisfying print so far....

Photo of a 3D printed holder for iPhone 13 mini from its side...

Downloaded from printables.com/…/437536-floating-plastic-ducks.

Should i worry? Any suggestions for a fix? Didnt find anything because i dont know what search terms to use…...

It’s basically a 10 inch screen matrix for SLA printers, a 130W blacklight lamp from Amazon and a ground glass for even lighting. The lamp gets very hot, so the two fans blow air over and under it (split cooling channel). The parts touching the lamp are printed in Greentec Pro Carbon, electronics box and cooling channel are...

The crown is a 3D printed replica of the crown from the movie The Green Knight, starring Dev Patel as Sir Gawain. Absolutely loved the costume design in that movie. Incorporating the halos depicted around royalty in illuminated manuscripts and other artworks into the crowns themselves to infer divinity was just so fucking cool...

Printed threads and snap connectors are nice, but M3 bolts and nuts are more robust and look dope. They also make the model easier to design and print, since you don’t have to worry about tolerances as much....

My first print (after a benchy test) with my new Sovol SV06 is the Maltese Falcon replica....

Had a long series of failed prints, tried levelling, replacing parts, nothing worked....