Dremel/Parkside Multi Grinder Holder by erevan12

This is an upgrade for the "Parkside Multi Grinder Holder" by rechena. Please also check the source creator. The changes are the following: The lower rear part has been reduced in height. The front part has been reduced in height, different for Parkside and Dremel. These changes were made to ensure the horizontality of the tool. Centering nuts were added, because the front support hole is wider. (3/4x12 for Dremel and 18x1.5 for Parkside) Screws have also been added to keep the original nuts when not in use. It is recommended that the nuts and screws be printed with the wider side down and at the finest resolution to ensure thread quality. Note: Fits Dremel 4000 and Parkside PFBS 160 C3