I was trying to iron a crease into my chinos and I just couldn't get them to line up nicely. I laid side seam on side seam for both legs, but from the knee upwards, the legs wouldn't lie flat and the crease I ended up ironing was wobbly at best.
What am I doing wrong? How do I do that better?
I iron on a table (with a heat-resistant ironing blanket underneath), not a board, if that's relevant.
Ich probiere gerade den #OrcaSlicer aus. Das ist schon ein schönes Teil an Software, hat nicht die unerträglichen Hänger von Cura, kann #Klipper direkt in der App anzeigen und die Modelle kommen auch noch besser raus. Die kleinen Optimierungen bringen schon in den Standardeinstellungen enorm was.
Der Top-Layer sieht aus, als wenn man Ironing angewendet hat und die Glättungsmethode ist dabei deaktiviert.
Der Übergang Fläche zu Wand ist erheblich besser, als in Cura.