3dprinting

Source twitter.com/E3DOnline/status/1774718483990823347...

Hi folks, this is a follow-up to my previous post here....

With 3D printers like the Open-5x or tool changers (e.g. Prusa XL) both, 5-axis simultaneous 3D-printing as well as hybrid manufacturing (additive followed up by subtractive), is more accessible than they ever were....

I think it’s finally time for a dryer box. Want something I can run filament out of directly to the printer. Right now considering space pi vs. Esun vs. Eibos. Ideally something I could run for just a little while before a print and during the print. Low noise also important. A decible chart for dryers would be nice if that...

On my ender 3 I have to turn the knobs on the bottom for leveling....

I’ve been using a rebranded Flashforge Adventurer 3 (it’s actually a Bresser Rex that I got 50% off at Aldi) and have been really happy with it. The build volume is a bit smallish, but for most of what I’m doing it’s fine....

I really like the design and iteration process he goes thru.

I left a spool of eSun PLA+ beige in my Prusa MK4 with Prusa enclosure, which has sat idle since my last print about 6 weeks ago. The enclosure has a PTFE filament feed tube that runs the filament from the spool to the extruder....

I am using OrcaSlicer/BambuStudio with the P1P. Also, the hotend currently has hardened steel gears and a 0.8mm nozzle....

The extruder of the 3Dgence P255 3d-printer features a brush to clean the extruder gear.

Got an anycubic resin printer and I’m using their high speed resin (because it was bundled for free), and i tried to send a file using the high speed setting....

I am woking on making solar panel mounts for the roof rack of my nissan xterra from TPU, since it can take a beating. Does any one have any experience with 3d-printed TPU threads? And how much stress before it can take before a bolt rips out? Also should i use teflon thread seal so the a bolt won’t come loose?

So, let’s say I have a mesh exported as a DAE file. Might be from a 3D scanner, might be from some photogrammetry using my quadcopter. I want to take measurements. Maybe put a plane through a house roof based on three points and then measure the angle towards the ground. Something like that....

When would be good times to use the organic supports and the snug supports on Prusaslicer? I know organic is good for small parts but like I can’t find anything that says what snug and organic is more optimal for

I was printing some last meters… Very last meters.

Hi guys, I’ve dove into the klipper scene with my Neptune 3 and am having a really odd issue....

Stl is printables.com/…/498730-raspberry-pi-3-model-b-ca…

Can i use a 3D Pen with ABS to glue small (20x20mm) glass tiles onto stone surface?...

I redesigned a dog poop bag holder and printed it out. The original model was good, but I don’t like flat over hangs. printables.com/…/812982-dog-poop-bag-roll-dispens… #3Dprinting

Hello there,...

Very Specific Objects are a lot of fun, so here’s another one....

cross-posted from: lemmy.world/post/13318099...