3DPrinting Top

Printables link...

A comprehensive mapping of old subreddits to new communities.

Was shocked to see just how broken my couch was when we took it apart. This part which is installed is replacing the cracked wood which was held in with just staples....

I've used this phone stand for a while but decided to reprint it in some new prusament PC blend carbon fiber I picked up recently. It prints beautifully and is incredibly rigid! My old ones printed in PLA and ASA feel like noodles in comparison....

Guide for lubricating motorcycle chains. Clips onto grease bomb Maximum chain width: 26mm Guide pour graisser les chaines de motos. Se clipse sur les bombes de graisse aerosol Largeur maximum de la chaine : 26mm Je peux faire d'autres versions plus larges ou plus étroites si besoin.

Local-only octoprint is feeling better and better.

Bring my buddy at work

0.6 nozzle and still got decent detail. Ive been having a ton of fun and productivity with the big nozzle but can’t wait to go back to 0.4 which I haven’t used in a long time, or to try out the 0.2

Printables page - Thingiverse page...

I haven’t done miniatures before. Printed it ultra fine detail with 0.05mm layers. This came as a kit-card with vestigial sprew work. www.thingiverse.com/thing:4679744 Fun little project. No glue required and fully articulated. For the grappling cable I use 24 gauge flower wire.

Recently my daughter has started getting into playing the ukulele, I ran across the instructables post and it seemed like a pretty straightforward project, so I went for it. Video of it playing (terribly) in the substack post. I hope you all enjoy the read....

removed some material to speed up print, still works great. geometry gives enough support. used 2 drywall self taps.

Hopefully this doesn’t violate the no ads rule, as it is my model. But I’m pretty proud of it and wanted to share....

Completed my Mandalorian costume just in time for Halloween.

I understand the intent, but feel that there are so many other loopholes that put much worse weapons on the street than a printer. Besides, my prints can barely sustain normal use, much less a bullet being fired from them. I would think that this is more of a risk to the person holding the gun than who it’s pointing at.

github.com/PCrnjak/PAROL6-Desktop-robot-armwww.youtube.com/watch?v=PiBCbHtvbpEpiped.video/watch?v=PiBCbHtvbpE...

Here is my first published print. It’s 3D printable wire duct. Working in industrial environments I’ve always leaned toward using wire duct for wire management. I couldn’t find any I liked so I set out to make my own....

My automatic dog feeders work great but only hold enough food for a few days so I designed and printed a funneling system and a resovoir to hold the entire bag so all I have to do is fill the resovoir when I get a new bag. Works great....

The other ones:...

Small latch for cabinet, little door, to attach something to other thing. Works well also as printer test. Gap between parts is 0.2 mm. Can be printed fully working on place without supports as shown on video. If you have problems with movement most likely problem is stringing. https://youtu.be/MCwRCMNyMc4

My wall power outlets at home do not have a center screw. Some 6 way splitters have a center hole so you can secure it to the outlet such that it won't pull away when you unplug something....